Netgear Extender Red Light: Troubleshooting Guide

Are you struggling with Netgear extender red light issue? Need not to worry! We have got you covered! Walk through the fixes provided here and know how to troubleshoot the issue while relaxing on your couch. Keep reading!

Why You are Getting Netgear Extender Red Light?

Before you jump to the fixes to troubleshoot the issue, let us make you aware of the reasons causing it.

Here is the list of the common reasons why you are seeing a red LED on your WiFi range extender:

• Poor or insufficient power supply to the extender
• Your range extender is placed in a bad location
• Partial configuration of the extender
• Unstable connection between your host router and WiFi extender
• Outdated firmware on the extender

Fixed: Netgear Extender Red Light

Fix 1: Restart Your Netgear Extender

A simple restart is more than enough to make your extender up and running and to fix the red light issue. So, without much delay, apply the guidelines highlighted below and know how to restart your WiFi range extender:

Step 1: Turn off your WiFi range extender.

Step 2: Disconnect your extender and router.

Step 3: Wait for a few seconds.

Step 4: Now, you can plug in your WiFi extender and reconnect it to your host router.

In this way, you can restart (power cycle) your WiFi extender.

Are you still struggling with the same issue? If yes, you must try the next hack highlighted below.

Fix 2: Check the Power Supply

Now, you need to check the power (electricity) being supplied to your WiFi range extender. Make sure that it (electricity) is steady and the power plug in which it (the extender) is plugged in is well working.

Bear in mind, a steady power supply from a non-damage socket is very important for your WiFi range extender to work well.

Fix 3: Reconfigure Your Netgear Extender

Partial configuration of your WiFi extender leads to the red light issue. For fixing it, we suggest you reset your Netgear WiFi range extender and configure it again in a proper way.

Fix 4: Verify the Extender-Router Connection

The “Netgear extender red light” issue may also persist because of an unstable connection between your extender and router.

For getting the issue fixed from the comfort of your home, we suggest you ensure a stable connection between your extender and router.

Important Points to Consider

If you want to make a wired connection between the devices, make sure to use a working Ethernet cable. Apart from this, the cable you have handy must be inserted firmly into the correct ports of your router and WiFi range extender.

On the other hand, if you want to make a wireless (wireless) connection between them, be certain that your existing device i.e. the router had the WPS button on it. And, if it has, press the WPS button on your router and then on your WiFi range extender.

Fix 5: Update Netgear Extender Firmware

An obsolete firmware on your WiFi extender leads to the red light issue. Hence, to improve the performance of your Netgear WiFi range extender and to fix various issues (including red light) with it, it is recommended that you update its firmware right away.

In future also, we advise you not to ignore the firmware updates notification. As soon as you get the notifications to update your WiFi extender firmware, straightaway do it.

That’s all! These are the fixes that you can apply to troubleshoot “Netgear extender red light” issue.

The Last Words

WiFi range extenders are the best devices that you must consider if you want to prevent WiFi lagging. Despite providing continuous internet connectivity, it is also prone to major technical issues. And, the Netgear extender red light issue is famous among them.

Now, we are going to conclude this post. We really hope that this blog post will prove helpful to you.